HP Envy 15 Maintenance And Service Manual page 70

CAUTION:
support the display assembly can result in damage to the display assembly and other computer
components.
2. Remove the four Phillips PM2.5×6.0 screws (1) that secure the display assembly to the base
enclosure.
3. Lift the display assembly (2) straight up and remove it.
4. If it is necessary to replace the display bezel or any of the display assembly internal components:
a.
62 Chapter 4 Removal and replacement procedures
Support the display assembly when removing the following screws. Failure to
Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge
(3) of the display bezel until the bezel disengages from the display enclosure.