Power Connector Cable - HP Envy 15 Maintenance And Service Manual

2. Detach the power button board cable (2) and power button board (3) from the base enclosure.
(The power button board cable and power button board are attached to the base enclosure with
double-sided tape.)
Reverse this procedure to install the power switch board.

Power connector cable

Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a.
b.
c.
56 Chapter 4 Removal and replacement procedures
Battery on page 36
Memory module compartment cover (see "Expansion memory module").
Top cover (see Top cover on page 39
Processor fan/heat sink assembly (see Processor fan/heat sink assembly on page 51
Spare part number
576846-001