Rename - Barco R9040380 Owner's Manual

11. Image Files Menu
Clamp width
Input format

11.6 Rename

What can be done?
This menu item is used to rename a custom source file.
How to Rename a file?
1. Press the MENU key to activate the Menu bar.
2. Push the cursor key ← or → to highlight Image Files in the menubar.
3. Push the ↓ key to pull down the Image Files menu.
4. Push the cursor key ↑ or ↓ to highlight Rename and press ENTER to select. (image 11-8)
The Rename custom file selection box will be displayed. (image 11-9)
5. Push the cursor key ↑ or ↓ to highlight the desired file and press ENTER to select.
The Rename custom file dialog box will be displayed. (image 11-10)
6. Use the cursor key ← or → , the numeric keys on the RCU, or the local keypad, to edit and change the values, confirm with
ENTER.
Image 11-8
Image 11-9
188
The width of the clamp pulse can be any value between 0 and 255.
These settings are used to "tell more" about the signals connected on the BNC's, it completes the
information in the source selection menu:
• RGB is selected by default and means that an RGB signal is connected to the BNC's.
• Pr/Y/Pb must be selected whenever:
- A progressive signal (32 kHz frequency video signal ) is connected to the BNC's (select the
source with Data on BNC's in the Source selection menu).
- One wants (in PiP mode) to visualize the component video signal in a Data window hereby
adding a video image in the PiP layout.
• HDTV-PR/Y/PB is used for high definition component video signals.
Image 11-10
R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007