Changing The Projector Address; Changing The Common Address - Barco Galaxy 4 Long Life+ R9040355 Owner's Manual

9. Service Mode
9.6.2

Changing the Projector Address

How to Change the Projector Address?
1. Push the cursor key ↑ or ↓ to highlight Projector Address. (menu 9-9)
2. Press ENTER to select.
The actual address is filled in.
The first digit is highlighted.
CHANGE PROJECTOR ADDRESS
PROJECTOR ADDRESS 6
COMMON ADDRESS (RC5) 0
COMMON ADDRESS (PPM) 0
Select with ↑ or ↓
then <ENTER>
Reprogram with ↑,↓,←,→
or numeric keys
<ENTER> to confirm
<EXIT> to return
Menu 9-9
How to Enter the new Projector Address?
1. Enter the digits with the digit keys on the RCU or local keypad.
Or,
push the cursor keys ← or → to select a digit and change the value by pushing the cursor key ↑ or ↓ until the new value is reached.
Continue with the other digits on the same way. The individual address must be between 0 and 255.
In a Linked CLO and/or Dynacolor™ setup a maximum of 14 projectors can be linked, all projectors must have
a different projector address between 0 and 13.
9.6.3

Changing the Common Address

How to Change the Common Address?
1. Push the cursor key ↑ or ↓ to highlight the active Common Address e.g. (RC5). (menu 9-10)
2. Press ENTER to select.
CHANGE PROJECTOR ADDRESS
PROJECTOR ADDRESS 6
COMMON ADDRESS (RC5) 0
COMMON ADDRESS (PPM) 0
Select with ↑ or ↓
then <ENTER>
Reprogram with ↑,↓,←,→
or numeric keys
<ENTER> to confirm
<EXIT> to return
Menu 9-10
Entering the new Common Address
1. Enter with the digit keys on the RCU or the local keypad
Or,
pushing the cursor key ↑ or ↓ until the new value is reached.
Only addresses between 0 and 1 are valid.
142 R5976780 GALAXY SXGA+ SERIES 14/10/2005