1.2 Cli Command Modes - TP-Link TL-SG3210 Cli Reference Manual

Now you can manage your switch with CLI commands through Telnet connection.
Note:
You can refer to Chapter 9 User Manage Commands
Telnet connection configuration.

1.2 CLI Command Modes

The CLI is divided into different command modes: User EXEC Mode, Privileged EXEC Mode,
Global Configuration Mode, Interface Configuration Mode and VLAN Configuration Mode.
Interface Configuration Mode can also be divided into Interface gigabitEthernet, Interface
link-aggregation and some other modes, which is shown as the following diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Mode Accessing Path
Primary mode once it
User EXEC
is connected with the
Mode
switch.
Use
Privileged
command to enter this
mode from User EXEC
EXEC Mode
mode.
Use
Global
command to enter this
Configuration
mode from Privileged
Mode
EXEC mode.
Use
gigabitEthernet
or interface
Interface
gigabitEthernet
Configuration
port-list command to
Mode
enter this mode from
Global
mode.
Prompt
TL-SG3424>
the enable
TL-SG3424#
the configure
TL-SG3424(config)#
the interface
port
range TL-SG3424(config-if)
TL-SG3424(config-if-
Configuration
for detailed commands information of the
Logout or Access the next mode
Use the exit command to disconnect the
switch
connected through the Console port).
Use the enable command to access
Privileged EXEC mode.
Use the exit command to disconnect the
switch
connected through the Console port).
Enter the disable command to return to
User EXEC mode.
Enter configure command to access
Global Configuration mode.
Use the exit or the end command or
press Ctrl+Z to return to Privileged
EXEC mode.
Use the interface gigabitEthernet port
or interface range gigabitEthernet
port-list command to access interface
Configuration mode.
Use the vlan vlan-list to access VLAN
Configuration mode.
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
# or Enter the exit or the # command to
return to Global Configuration mode.
range)#
A port number must be specified in the
interface command.
11
(except that the switch
(except that the switch
is
is