Optical drive SATA cable and connector
Description
Optical drive cable (included in the cable kit)
Before removing the optical drive cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
WLAN (see
c.
Optical drive (see
d.
Keyboard (see
e.
Top cover (see
f.
Speaker assembly (see
g.
Display assembly (see
h.
System board (see
Remove the optical drive cable
1.
Remove the two Phillips PM2.5×6.0 screws (1) that secure the optical drive connector to the
system board.
Battery on page
Hard drive on page
WLAN module on page
Optical drive on page
Keyboard on page
56)
Top cover on page
58)
Speaker assembly on page
Display assembly on page
System board on page
45).
46)
51)
49)
61)
73)
80)
Component replacement procedures
Spare part number
610791-001
83