Pc Card Assembly - HP 8510w Maintenance And Service Manual

j. Speaker assembly (see
k. Modem module (see
l. System board (see
Remove the RJ-11 connector cable:
1. Remove the RJ-11 connector (1) from the clip built into the base enclosure.
2. Remove the RJ-11 connector cable from the clips and routing channel (2) built into the base
enclosure.
3.
Remove the RJ-11 connector cable from the base enclosure.
Reverse this procedure to install the RJ-11 connector cable.

PC Card assembly

Description
PC Card assembly
Before removing the PC Card assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
Speaker assembly on page
Modem module on page
System board and system board frame on page
87)
89)
90)
Component replacement procedures
Spare part number
455893-001
95