Interrupting A Programme - Zanussi ZWT 3202 User Manual

«Delay start»
This option allows you to delay the start of a
wash programme by 3, 6 or 9 hours by pressing
the «Delay start» pushbutton.
You can change or cancel the delayed start time
at any time before you press the «Start/Pause»
pushbutton, by pressing the «Delay start»
pushbutton again (when all indicators are off, the
wash programme will start immediately).
If you have already pressed the «Start/Pause»
pushbutton and you want to change or can-
cel the delayed start, proceed as follows :
• To cancel the delayed start and start the cycle
immediately, press «Start/Pause»
then «Delay start» . Press «Start/Pause»
to start the cycle.
• To change the timer delay period, you must go
through the «Off» position and reprogram
your cycle.
WARNING !
The lid will be locked during the delayed start
time. If you need to open it, you must first pause
the appliance by pressing the «Start/Pause»
pushbutton. After closing the lid again, press the
«Start/Pause» pushbutton.
Start of the programme
Press the «Start/Pause»
pushbutton to start the cycle ;
the corresponding light will
come on green.
It is normal for the programme
selector to remain stationary during the cycle.
The light corresponding to the
current cycle is illuminated.
: Prewash + Wash
34
: Rinse + Spin
: End of cycle

Interrupting a programme

Adding washing during the first 10 minutes
Press the «Start/Pause»
corresponding light will flash green while the
appliance is paused. The lid can only be opened
around 2 minutes after the washing machine has
come to a stop. Press the «Start/Pause»
pushbutton again to continue the programme.
Modifying the programme in progress
Before making any changes to the current pro-
gramme, you need to pause the washing
machine by pressing the «Start/Pause»
and
hbutton. If the modification is not possible, the
«Start/Pause» pushbutton flashes red for a
few seconds. If you still decide to change the
programme, you must cancel the current pro-
gramme (see below).
Cancelling the programme
If you want to cancel the programme, turn the
programme selector to the «Off»
End of the programme
The washing machine stops automatically ; the
«Start/Pause» pushbutton goes out and the
light «End» comes on. The lid can only be
opened around 2 minutes after the washing
machine has come to a stop.
Turn the programme selector to the «Off»
position.
Remove washing
Unplug and close water inlet tap.
WARNING !
We recommend leaving the lid and drum open
after use to ventilate the water tank.
pushbutton : the
pus-
position.