Interrupting A Programme And Changing The Options; Cancelling A Running Programme; Opening The Door When The Programme Operates - Zanussi ZWF725B4PW User Manual

You can cancel or change the set of
the delay start before you press the
. To cancel the delay start:
• Press
to pause.
• Press
shows
• Press
programme immediately.
THE AUTOSENSE SYSTEM LOAD
DETECTION
After touching the Start/Pause
1. The AutoSense System starts estimating the
weight of the load to calculate the real
programme duration. During this phase the
display shows the simple animation.
2. After about 10-15 minutes new cycle duration
is displayed.
The appliance automatically adjusts the
programme duration to the load to achieve
perfect washing results in the minimum
possible time.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press .
The indicator flashes.
2. Change the options.
3. Press again.
The programme continues.

CANCELLING A RUNNING PROGRAMME

1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
20
to set the appliance
until the display
'.
again to start the
button:
to
OPENING THE DOOR WHEN THE DELAY
START OPERATES
While a delay start operates, the appliance door is
locked and the indicator
1. Press to pause the appliance.
The indicator starts flashing.
2. Wait about 2 minutes until the door lock
indicator stops flashing and goes off.
3. You can open the door.
4. Close the door and press the
The delay start continues to operate.
OPENING THE DOOR WHEN THE
PROGRAMME OPERATES
While a programme operates, the appliance door is
locked and the indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
1. Turn the programme knob to position
deactivate the appliance.
2. Wait for some minutes and then open the
appliance door.
3. Close the appliance door.
4. Set the programme again.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display comes on.
• The indicator of the
• The door lock indicator
minutes, then goes off.
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.
• Turn the programme knob to position
deactivate the appliance.
• Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The door lock indicator
flashes. The door stays locked.
• You must drain the water to open the door.
To drain the water:
is on.
again.
is on.
to
goes off.
flashes for a few
to
is on. The indicator