Cleaning And Maintenance - Zanussi ZDC47100G User Manual

lights will flash. The drum turns alternately in both direc-
tions during drying.
All drying programmes end with a 10 minute cooling
phase. You may remove the laundry after this phase.
If the door of the appliance or the small door at the bottom
is opened while the programme is running, this button
must be pressed again after closing the door in order to
restart the programme from the point at which it was in-
terrupted. This button must be depressed also after a
power failure and after having reinserted the water reser-
voir, if it has been emptied in the middle of a programme
after lighting up of light Empty Tank .
In both cases the light of the Start/Pause button flashes
to remind you that the start button needs to be pressed
again.
Indicator lights
These lights indicate the following functions:
• Drying light: This light indicates that the appliance is
in the drying phase.
• Cooling light: This light indicates that the appliance is
in the cooling phase. At the end of drying, there is a
10 minute cooling phase to cool the laundry.
• End/Anticrease light: This light is on at the end of the
cooling phase, during the anticreasing phase and at
the end of the programme.
• Condenser light: It comes on every 80 cycles to remind
you that the condenser must be cleaned.
• Filter light: This light illuminates at the end of the pro-
gramme to remind you that the filters must be cleaned.
• Empty Tank light: This light indicates that the appliance
is in the drying phase. This light comes on at the end
of the programme to remind you that the water reservoir
must be emptied out. If this light illuminates during a
programme this means that the water reservoir is full.
The buzzer sounds, the programme stops, the light of
the Start/Pause button flashes. This light comes on
also when the water reservoir is not inserted correctly.

Cleaning and maintenance

Cleaning lint filters
To ensure that the appliance works perfectly, the lint filters
in the door and in front of the drum must be cleaned after
every drying cycle.
Caution! Important. Never operate the dryer without
the lint filter or with a damaged or blocked lint filter.
1) Only dryers with buzzer button
8
Changing programme
To change a programme which has been selected by mis-
take once the programme has started, first turn the pro-
gramme selector to - O OFF position. The programme is
cancelled.
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob or if an function button (excluding the
1)
BUZZER button ) is pressed, led on the START/PAUSE
button starts flashing temporarily in red. The drying pro-
gramme is not however affected by this (laundry protec-
tion).
At the end of the programme
If the laundry is not removed at the end of the cycle, the
dryer performs an anticreasing phase (duration: 30 mi-
nutes maximum).
If you do not remove the laundry, the dryer will stop au-
tomatically at the end of the anticreasing phase. Lights
End/Anticrease , Filter and Empty Tank remain lit and
the buzzer sounds for 2 minutes.
Turn the programme selector dial to " O " to switch the
machine off. Remove the laundry from the drum and care-
fully check that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
If you open and then close the door before turning
the selector dial to " O " all the lights corresponding
to the phases making up the performed programme come
on.
After each use
• Clean the filters.
• Empty the water reservoir.