Zanussi ZDC47100G User Manual page 9

1. Open loading door
3. Use a damp hand to
clean the micro- fine filter,
which is built into the low-
er part of the loading aper-
ture.
Cleaning heat exchanger
Clean the condenser when light Condenser comes on.
The condenser is situated at the lower part of the cabinet
behind a small door.
2. After a period of time, a
gleam due to detergent
residue on laundry forms
on the filters. To prevent
this clean the filters with
warm water using a brush.
Remove the filter from the
door pulling it out.
4. Remove fluff from lint
filter, preferably using a
damp hand for this pur-
pose.
Replace the filter.
1. To open the door, push
the catch as per picture.
During the drying cycle or
at the end, it is normal for
water to be present on the
surface of the condenser
insertion.
3. Pull out the condenser
unit holding it at the han-
dle .
Important! Do not use pointed objects or utensils to clean
the spaces between the plates, as this could damage the
condenser and make it permeable. Re-fit the condenser,
turn the red stops upwards and close the door.
Important! Do not use this appliance if the condenser has
not been fitted.
Emptying the water reservoir
Water extracted from the laundry condenses inside the
machine and is collected in a reservoir. The reservoir must
be emptied after each drying cycle to ensure efficient op-
eration when the machine is next used. The pilot light
Empty Tank reminds you this operation.
2. Turn the two red stops
downwards.
4. Clean it with a brush and
rinse it under the shower if
necessary. Also clean the
outside, removing all fluff.
Clean the rubber seal
round the condenser cab-
inet and in the inner part of
the small door with a damp
cloth.
9