Machine Settings - Zanussi ZDC47100G User Manual

Loading door does not close.
When a button is pressed - no
reaction of the machine.
Drying cycle ends shortly after
programme starts. End/Anti-
crease light illuminated.
Programme inactive, Empty
Tank full light illuminated.
Drying cycle lasts an unusually
long time. Note: After up to 5
hours the drying cycle ends au-
tomatically (see 'End of drying
cycle').

Machine settings

BUZZER permanent off
1. Turn the programme selector to any programme.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with lint.
Overloading of laundry.
Ventilation slots in base area covered
up.
Residue on inside surface of drum or
drum ribs.
Fine strainer not in place and/or large
mesh filter not locked in place.
Drying protection. After the start of the
programme, the option can no longer
be set.
Not enough washing loaded or washing
loaded is too dry for selected pro-
gramme.
Condensate tank is full.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temperature.
Temporary switching off of the com-
pressor to avoid overload.
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading vol-
umes.
Uncover ventilation slots in base area.
Clean inside surface of drum and drum
ribs.
Install fine strainer and/or snap large
mesh filter into place.
Turn the programme knob to O
the programme again.
Select time programme
Empty condensate tank, then start pro-
gramme with START/PAUSE button.
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately spun.
Automatic process, there is no fault
with the appliance. If possible, lower
the room temperature.
2. Press simultaneously the DELICATE and TEXTILE
buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
off
. Set
11