Care And Cleaning - Zanussi ZDF 4010 User Manual

You can set a programme, options and the
delay start also with the appliance door
closed. In this condition, you only have 3 sec-
onds after each setting before the appliance
starts to operate.
Opening the door while the appliance
operates
If you open the door, the appliance stops. When
you close the door, the appliance continues
from the point of interruption.
Cancelling the delay start while the
countdown operates
Press and hold function buttons (B) and (C) at
the same time, until all the programme indica-
tors come on.
When you cancel a delay start, the appli-
ance goes back to setting mode. You have
to set the programme again.
Cancelling the programme
Press and hold function buttons (B) and (C) at
the same time, until all the programme indica-
tors come on.
Make sure that there is detergent in the de-
tergent dispenser before you start a new
programme.

Care and cleaning

Warning! Before maintenance, deactivate
the appliance and disconnect the mains
plug from the mains socket.
Dirty filters and clogged spray arms de-
crease the washing results.
Make a check regularly and, if necessary, clean
them.
10
At the end of the programme
When the programme is completed the display
shows 0 and the wash indicator goes off.
1. Press the on/off button to deactivate the ap-
pliance.
2. Close the water tap.
• If you do not deactivate the appliance,
after three minutes from the end of the
programme:
– All the indicators go off.
– The display shows one horizontal sta-
tus bar.
This helps to decrease the energy con-
sumption.
Press one of the buttons (not the on/off
button), the display and the indicators
come on again.
• Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.
• There can be water on the sides and on
the door of the appliance. Stainless steel
becomes cool more quickly than the
dishes.
Cleaning the filters
1
C
B
A
2
www.zanussi.com