Zanussi ZOD370 User Manual page 14

Shelf Support Rails
Removing the shelf support rails
1
Pull the front of the
shelf support rail away
from the side wall.
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must
point to the front!
Oven Ceiling
You can fold down the heating element on the oven ceil-
ing to clean the oven ceiling easily.
Warning! Before you fold down the heating element
switch off the appliance. Make sure that the
appliance is cold.
There is a risk of burns!
Folding down the heating element
1. Remove the shelf support rails.
2. Hold the heating element with the two hands at the
front
3. Pull it forwards against the spring pressure and out
along the support on both sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
14
2
Pull the rear shelf sup-
port rail away from the
side wall and remove it.
Installing the heating element
1. Install the heating element in opposite sequence.
Important! Install the heating element correctly on the two
sides above the support on the inner wall of the oven.
2. Insert shelf support rails.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the door from
the appliance. The door is heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two door hinges
fully.
A
3. Close the oven door until the first position (angle
approx. 45°).
A