Bang & Olufsen BEOSOUND 5 User Manual page 15

Secure the cables ...
1. Insert the cables (VIDEO, USB and POWER) into
the corresponding sockets in the base of the music
system. Note: Place a cable binder behind the USB
plug (A).
2. Run the USB cable through the cable holder.
...
3. Run the POWER cable under the USB cable and
over the VIDEO cable, and then through the cable
holder.
4. Run the VIDEO cable under the USB and POWER
cables, and then through the cable holder. Finally,
to secure the cables, tighten the cable binder (A).
Make basic settings
Mount CD-Rip
For instructions on how to mount the
optional CD Ripping Device together with
your music system, see the instructions
enclosed with the CD Ripping Device.
Note that it should be mounted by
a Bang & Olufsen retailer.
Settings For further information about Settings, refer to the Guide on
www.bang-olufsen.com/guides.
The supplied mains cord and plug are specially designed for the product.
If you change the plug or damage the mains cord, you must buy another
from your Bang & Olufsen retailer.
A
VIDEO POWER
USB
POWER
Connect BeoMaster 5 to the
mains supply
A
VIDEO
Activate a BeoSound 5
source
NOTE! See the BeoMaster Guide for information
about the connections.
The music system can only be switched off
completely by disconnecting the BeoMaster from
the mains.
15
USB
Follow the on-screen
instructions