Bradford White EFR160T120 Series Installation & Operating Manual page 57

Ef series ultra high efficiency gas water heater

Hide thumbs Also See for EFR160T120 Series:

Table of Contents

To change the Maximum Setpoint Limit (Max Setpoint) for the temperature setpoint:

Setting the water temperature to the maximum set point can result in scalding hot water delivered to the

faucets. It is highly recommended that the maximum setpoint be adjusted to the lowest temperature

possible for the needs of the installation. See following section to change the maximum setpoint limit

(max setpoint).

temperature settings being improperly adjusted. See previous warning on scalds and an ASSE approved

mixing valve.

Step 1: In service mode press the "Select" button until "Max Setpoint" is displayed.

Step 2: Press "Set" button to enter setting mode. "Max Setpoint" will flash to indicate setting mode.

Make sure the water heater control display is not in a public area that can result in the

WARNING

Max

°F

Setpoint

idle

Operational

Status

SELECT

SET

Max

°F