Step 3: Press the "UP" or "DOWN" buttons to change the maximum setpoint value. This will limit the maximum setpoint the
user can select. Note: The maximum setpoint is approximately 180˚F (82˚C).
Step 4: Press "Set" button to confirm new "Max Setpoint" value and stop setting mode.
Step 5: 30 Seconds after the last button press, the Water Heater Display will go back to "User Mode". It will read "Max
Setpoint" without showing a temperature value if the temperature setpoint is at the maximum setting. The Water Heater
Display can be set back to the "User Mode" immediately by pressing both the "Temperature Up" and "Select" buttons
together for 3 seconds.
idle
Status
SELECT
idle
Status
SELECT
idle
Status
SELECT
Exiting Service Mode
Max
°F
Setpoint
Operational
SET
"Max Setpoint" stops flashing
Max
°F
Setpoint
Operational
SET
Max
Setpoint
Operational
SET
58
"Max Setpoint" continues to
while making adjustments
flash