Bradford White EFR160T120 Series Installation & Operating Manual page 53

ACCESSING SERVICE MODE ON THE WATER HEATER DISPLAY (FOR SERVICE
PERSONNEL ONLY)
The display has a "Service Mode" for changing the maximum setpoint and accessing information in aiding servicing of
the water heater. This procedure is for service and installation personnel only. To enter the Service Mode, follow the
steps illustrated below:
The following procedure is for service and installation personnel only. Resetting lockout conditions
without correcting the malfunction can result in a hazardous condition.
Step 1: Press "Select" and "Temperature Up" buttons together and hold for 3 seconds until "Max Setpoint" is shown in
the display.
30 Seconds after the last button press, the display will automatically return to the "User Mode".
Simultaneously pressing the "Select" and "Temperature Up" buttons will switch the display immediately to
the "User Mode".
Step 2: Pressing "Select" button will change display to next mode
WARNING
idle
Status
SELECT
NOTICE
idle
Status

SELECT

Max
°F
Setpoint
Operational
SET
Water
°F
Temp
Operational
SET
53
"Max Setpoint"
next to Temperature
Setpoint value.