Seat Installation - Pride Mobility JET 1 Owner's Manual

SEAT INSTALLATION

WARNING ! Do not pick up the seat frame by the
armrests. They are free to pivot, and you may lose
control of the seat if they do so, resulting in personal
injury or damage to the chair.
To install the seat:
1. Position the seat post above the seat tower. See figures 8 and 9.
2. Push the seat down until the latch engages. See figure 9.
3. Plug the controller harness into the connector on the utility tray.
See figure 10.
JOYSTICK INSTALLATION
If your Jet 1 is equipped with a Dynamic joystick controller (see
figure 11), it may have been shipped without the joystick installed in
the armrest.
Figure 9. Seat Installation
Figure 11. Dynamic Joystick Controller
22
V . A S S E M B L Y
www.pridemobility.com
Figure 8. Seat Tower
Figure 10. Controller Harnesses
SLIDE JOYSTICK
INTO BRACKET
SETSCREW
Figure 12. Joystick and Bracket
US Jet 1 ATS/Rev B/Jul03
SEAT
TOWER
PLUG IN CONTROLLER
HARNESSES