M.swing-Away Hangers & Footrests; Articulating Legrest & Elevating Legrest; Caster Plates - Sunrise Medical BREEZY SERIES User Instruction Manual & Warranty

X . S E T U P & A D J U S T M E N T
K. SWING-AWAY HANGERS &
FOOTRESTS (60º OR 70º)
1. Installation
a. Place swing-away pivot saddle into the
receiver on front frame tube with the
footrest facing outward from the frame.
b. Rotate the footrest inward until it
locks into place on locking bolt.
2. Removal
a. To remove footrest, push release latch
toward the frame.
b. Rotate footrest outward and lift.
3. Height-Adjustment
a. Remove retaining bolt in the frame tube.
b. Slide footrest tubes up or down inside
frame tube to desired height.
c. Align predrilled holes in footrest and
reinsert bolts.
d. Tighten bolts.
4. Footplate Angle-Adjustment
a. Loosen the retaining bolt in the frame
tube.
b. Reposition footplate to desired angle
and re-tighten bolt.
930300 Rev. C
Breezy 500
Breezy 510 & 600
40
X . S E T U P & A D J U S T M E N T
L. ARTICULATING LEGREST &
ELEVATING LEGREST (Optional)
1. Installation
a. Follow same steps as for swing-away
hangers and footrests. (p. 40)
2. Adjustment
a. List legrest to chosen position. Legrest
will lock in place.
b. To lower legrest, press release lever
(1) forward and lower legrest to chosen
position. Legrest will lock in place.
M. CASTER PLATES
(not available on the 500)
Note: Use a torque setting of 50-65 in./lbs.
(5.6-7.3 N . m) when adjusting caster angle.
1. Angle Adjustment
a. Loosen the two eccentric bolts that
secure the caster assembly. Do not
remove the clevis pin.
b. Place a large right triangle against the
table surface and the front surface of
the caster bearing housing.This will
align the caster stem rotational axis
perpendicular to the floor surface.
c. When alignment is satisfactory,
retighten the two eccentric bolts.
d. Repeat the process for the other.
1
41
930300 Rev. C