Canon LEGRIA HF R56 Instruction Manual page 150

[Displayed Units]: In recording mode, this setting selects the units to use for
the focusing distance display during manual focus. It also affects the units
used in the stamps for height and weight in
[File Numbering]:
which are assigned consecutive file numbers. This setting determines how
files are numbered.
[m Reset]: File numbers will restart from 100-0001 every time you
record on a memory that has been initialized.
[n Continuous]: File numbers will continue from the number following
that of the last file recorded with the camcorder.
• If the memory card you insert already contains a file with a larger num-
ber, a new file will be assigned a number one higher than that of the last
file on the memory card.
• We recommend using the [n Continuous] setting.
• A folder can contain a maximum of 500 files (MP4 movies and photos
combined).
• File numbers consist of 7 digits, for example "101-0107". The 3 digits
before the hyphen indicate the folder where the file is saved and can
range from 100 to 999. The 4 digits after the hyphen are a unique iden-
tifier for each file and can range from 0001 to 9900.
• The last four digits of the folder name indicate the date when the folder
was created.
• The file number and folder name also indicate the location of the file on
the memory card. A recording with the file number "101-0107", made
on 3 November will be found in the folder DCIM\101_1103. If it is an
MP4 movie, its file name will be MVI_0107.MP4; if it is a photo, its file
name will be IMG_0107.JPG.
[Auto Power Off]:
by a battery pack, it will automatically shut off if left without any operation
for 3 minutes.
• Approximately 30 seconds before the camcorder shuts off, [Auto Power
Off] will appear. Operating any of the camcorder's controls while the
message is displayed will prevent the camcorder from shutting off.
[Power On Using LCD Panel]:
the LCD panel turns the camcorder on, while closing the LCD panel turns
it off. Set to [Off] to deactivate this feature. In either case, you can still use
[.
[Firmware]:
In playback mode, you can verify the current version of the
camcorder's firmware, which is the software that controls the camcorder.
This menu option is usually unavailable.
150
Additional Information
MP4 movies and photos are saved as files in folders,
In order to save power when the camcorder is powered
When this setting is set to [Enable], opening
mode.