Contents; Quick Start - NEC MultiSync E224Wi User Manual

Contents

Your new NEC LCD monitor box* should contain the following:
• LCD monitor with tilt base
• Power Cord
• Video Signal Cable (DVI-D to DVI-D cable)
• Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)
• Setup Manual
• Base Stand
2
• Audio cable*
Setup Manual Power Cord*
* Remember to save your original box and packing material to transport or ship the monitor.
* 1 Type of power cord included will depend on the where the LCD monitor is to be shipped.
2
* E243WMi only.

Quick Start

To attach the Base to the LCD stand:
1. Place monitor face down on a non-abrasive surface (Figure 1).
NOTE: Handle with care when monitor facing down, for avoiding damage to the front control buttons.
2. Please pivot base 90 degrees as shown in Figure 1.
NOTE: Handle with care when pulling the stand.
3. Attach the base stand to LCD monitor and properly lock screw of base stand bottom (Figure 2).
NOTE: Reverse this procedure if you need to re-pack the monitor.
1
Video Signal Cable
Figure 1
Audio Cable*
DVI-D to DVI-D Base Stand
cable
English-6
2
LCD monitor
(Base Stand not connected)
Screw
Figure 2