Bissell 24A4 SERIES User Manual page 12

O
perations
Portable spot cleaning mode continued
Cleaning with Deep Reach™ Tool
1. set tool on soiled surfaces and press the
trigger to spray solution onto the soiled
area to be cleaned.
2. slowly move the tool back and forth
over the soiled surface, keeping the tool
in contact with the carpet.
Release trigger and move tool slowly
over the soiled area to suction up
water and dirt.
4. continue to clean the area, working
in small sections, until no more dirt
can be removed.
Empty dirty tank
follow the instructions under empty dirty
tank section on page 9 of the upright
cleaning mode section.
Replacing portable machine on base
1. align the product with the cord side on
the left and hose side on the right.
2. Push down the portable spot cleaner
until both sides click securely into place.
test the fit by pulling up on the carry
handle to make sure it is secure. to
further check if the portable spot cleaner
is secure, plug in and turn on to verify
that the heat indicator light is illuminat-
ed. if the heat indicator light does not
illuminate, release the pod and re-secure
by pushing firmly until both sides snap
into place.
Cleaning portable machine
1. Remove and rinse the tools in clean,
running water. dry and replace in the
tool storage provided.
2. it is recommended that you suction clean
water from a bowl to rinse out the hose.
then lift end of hose and stretch out to
ensure all water is cleared from hose.
3. coil flex hose around the hose wrap
and secure with latch.
4. check suction gate and if it appears
dirty, follow steps 1-4 under cleaning
suction gate on page 13.
12
1.
3.
1.
CORD
SIDE
HOSE
SIDE