Assembly Instructions - Bissell 24A4 SERIES User Manual

A
ssembly
Your deep cleaner comes in two
easy to assemble components:
1. upper handle
2. Portable spot cleaner/base
The only tool you will need to
assemble your cleaner is a Phillips
screwdriver.
1. slide the upper handle onto the body
of the machine by guiding the 2 posts
on the body into the opening on the
upper handle.
2. firmly holding the upper handle in
place, screw 2 screws into the marked
holes at an upward angle above the
support handle.
3. at an upward angle, screw the remaining
2 screws into the marked outermost holes
under the support handle.
4. Wrap power cord around Quick
Release cord Wrap.
5. Wrap flex hose around the hose wrap
Slide the upper handle onto
and secure with hose secure latch.
the body of the machine by
guiding the 2 posts on the
body into the opening on
6. align the product as image 4 shows
the upper handle.
and firmly push down the portable spot
cleaner until it is secured on both sides.
7. check latches on both sides to confirm
it is secured (5).
to further check if the portable spot
cleaner is secure, plug in and turn on
to verify that the heat indicator light is
illuminated. if the heat indicator light
does not illuminate, release the pod
and re-secure by pushing firmly until
both sides snap into place.
8. snap attachment(s) into the back of unit.
NOTE: Portable spot cleaner must
be fully secure to operate in the
upright mode.
6
w w w . b i s s e l l . c o m
IMPORTANT

ASSEMBLY INSTRUCTIONS

Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembly.
Firmly holding the upper
handle in place, screw 2
screws into the marked
holes at an upward angle
above the support handle.
1. 2.
IMPORTANT
ASSEMBLY INSTRUCTIO ASSEMBLY INSTRUCTIO
Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for assembl Use a minimum of a #2 x 4" or #2 x 100mm Philips screwdriver for asse
1.
Slide the upper handle onto Slide the upper handle onto
3.
the body of the machine by the body of the machine by
guiding the 2 posts on the guiding the 2 posts on the
body into the opening on body into the opening on
the upper handle. the upper handle.
At an upward angle, screw
the remaining 2 screws into
the marked outermost holes
5.
under the support handle.
WARNING:
do not plug in your cleaner
until you have completely
assembled it per the above
instructions and are familiar
with all instructions and
operating procedures.
IMPORTANT
2.
Firmly holding the upper Firmly holding the upper At an upward
4.
handle in place, screw 2 handle in place, screw 2 the remaining
screws into the marked screws into the marked the marked ou
holes at an upward angle holes at an upward angle under the sup
CORD
above the support handle. above the support handle.
SIDE
8 0 0 . 2 3 7 . 7 6 9 1
At an upwa
the remain
the marked
under the
HOSE
SIDE