SOYO SY-P4X400 DRAGON Lite User Manual page 25

Hardware Installation SY-P4X400 DRAGON Ultra
2. Reset
Plug the Reset push-button cable into the 2-pin Reset header on the
Motherboard. Pushing the Reset button on the front panel will cause the
system to restart the boot-up sequence.
Reset Pin Assignment
1
Power Good GND
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker header on
the Motherboard.
Speaker Pin Assignment
_
+
Speaker out
+5V NC NC
4.
IDE LED
Attach the 2-pin IDE device LED cable to the corresponding IDE LED
header on the Motherboard. This will cause the LED to lighten when an IDE
active.
(HDD, CD-ROM) device is
HDD LED Pin Assignment
_
+
LED Anode LED Cathode
20