SOYO SY-P4X400 DRAGON Lite User Manual page 37

Hardware Installation
Warning: Follow these precautions to preserve your Motherboard
from any remnant currents when connecting to ATX power supply:
Turn off the power supply and unplug the power cord of the
ATX power supply before connecting to ATX PW connector.
The Motherboard requires a power supply with at least 250 Watts and a
"power good" signal. Make sure the ATX power supply can take at 1.5 A
max current * load on the 5V Standby lead (5VSB) to meet the standard
ATX specification.
Note:
ATX 12V power supply is different from the normal ATX power
supply.
If you use the Wake-On-LAN (WOL) function, make sure the
ATX power supply can support at least 720 mA on the 5V
Standby lead (5VSB).
Please install the ATX power according to the following pin assignment:
ATX Power
12V
5VSB
PW-OK
GND
5V
GND
5V
GND
3.3V
3.3V
Pin3
+12VDC
com
Pin1
5V
5V
-5V
GND
GND
Pay special care to the directionality.
GND
PS-ON
GND
-12V
3.3V
+12VDC
com
P1
SY-P4X400 DRAGON Ultra
32