Subsequent use
1
Before every treatment, clean the attachment, the light exit window
and the metallic frame inside the attachment of Philips Lumea. For
more information see chapter 'Cleaning and maintenance'.
2
Press the on/off button to switch on the appliance.
Note: It is normal that the appliance and the attachment become warm during
use.
3
Start each treatment by selecting the light intensity very carefully,
based on your skin's sensitivity and on how comfortable treatment
feels.
Your skin may react differently on different days/occasions for a number of
reasons and especially after tanning. See section 'Possible side effects and
skin reactions' in this chapter for more information.
4
Press the % button to increase the intensity. To lower the intensity,
press the ^button.
Every time you press the button, the corresponding intensity
,
light starts to flash. This takes a few seconds.
5
Place the appliance at a 90° angle on the skin so that the attachment
and the safety ring are in contact with the skin.
6
Press the safety ring fully onto the skin with slight pressure.
Note: The safety ring has contact switches that together are the safety system
of the appliance. This safety ring prevents unintentional flashing without skin
contact.
EngliSh
17