Configure Gps Settings; Change Gps Parameters; Reset The Gps - GE MultiSync 100 Instruction Manual

CONFIGURE GPS SETTINGS

Configure GPS settings

Change GPS parameters

Reset the GPS

46
Use the GPS tab to view satellite coverage, change GPS parameters, and reset the GPS.
1. Click the GPS tab in the GE Config window.
2. In the Config area, set the Mask Angle to between 0 and 90 degrees.
Mask angle is the lowest angle, in degrees above the horizon, included in the field of
view used by the GPS when searching for satellites suitable for calculating the time.
Setting a larger mask angle may help eliminate timing errors resulting from multi-path
satellite signals which are low in the sky. The default mask angle is 5 degrees.
3. In the Config area, set the Cable Delay in ns.
Cable delay indicates the signal delay introduced by the length of the antenna cable.
To optimize precision, enter a value of 4 ns per meter of antenna cable.
4. Click the Update icon
changed configuration to the clock.
1. Click the GPS tab in the GE Config window.
2. Click Reset GPS, and confirm when prompted.
Clicking Reset GPS resets the on-board GPS receiver in the MultiSync 100, which may
take a few minutes to restart.
at the top of the GE Config window to save the
MULTISYNC 100 GPS CLOCK – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES