Configure Access Control Settings - GE MultiSync 100 Instruction Manual

CONFIGURE ACCESS CONTROL SETTINGS

Configure access control settings
44
Use the Access Control tab to assign access levels to different user groups. User groups
are defined in the User tab.
1. Click the name of a user group.
Access levels cannot be changed for the Administrator user group. Move users to a
different user group if you need to change access levels.
2. On the Clock Settings tab, click the radio buttons to set user group access levels for
different clock settings.
Refer to the following table for the effect of different Access Control tab setting:
Clock Setting Controls Access to...
Information Maintenance tab: Clock Designation, Clock Location, Clock Contact, the License
entry, and System Information
Read Only access (no Read Write access available):
Clock tab: Model and Firmware Version
Network tab: IP address, Netmask, and MAC address under Network Information
GPS tab: antenna connection status
Clock Clock tab: Time and Localization (DST)
Network tab > NTP > Advanced Options > Client (SNTP): SNTP client offset from
master
I/O I/O tab: I/O Ports P1 and P2, Sync area report settings (not Holdover time).
Note: If both I/O and Notifications access is set to None, the I/O tab is removed.
Notifications Network tab: Notifications sub-tab
I/O tab: RELAY-Alarm Output configuration, Sync area Holdover time.
CHAPTER 4: INTERFACES
MULTISYNC 100 GPS CLOCK – INSTRUCTION MANUAL