S-Ata Connectors; Usb Headers; Fan Connectors; Audio Connectors - Foxconn 661FX7MJ Series User Manual

S-ATA Connectors: SATA_1, SATA_2(optional)
The Serial ATA connectors are used to connect
the S-ATA devices to the motherboard. These
connectors support the thin Serial ATA cables
for primary internal storage devices. The cur-
rent Serial ATA interface allows up to 150MB/s
data transfer rate.
USB Headers: F_USB1, F_USB2
Besides four USB ports on the rear panel, the
series of motherboards also have two 10-pin
header on board which may connect to front
panel USB cable (optional) to provide addi-
tional four USB ports.
Fan Connectors: CPU_FAN, SYS_FAN
The speed of CPU_FAN and FAN1 can be de-
tected and viewed in "PC Health Status" sec-
tion of the CMOS Setup. These fans will be au-
tomatically turned off after the system enters
suspend mode.
Audio Connectors: CD_IN, AUX_IN(optional)
CD_IN, AUX_IN are Sony standard CD audio connector, it can be connected to
a CD-ROM drive through a CD audio cable.
CD_R
GND
1
CD_L
Chapter 2
CD_IN
1
Installation Instructions
GND
TX+
TX-
GND
RX-
RX+
GND
SATA_1,SATA_2
VCC
VCC
D-
D-
D+
D+
GND
GND
Empty
NC
F_USB1/2
CONTROL
S ENS E
POW ER
1
GROUND
GND +1 2V
SENSE
1 SYS_FAN
AUX_R
GND
AUX_IN
AUX_L
1
CPU_FAN
15