Connecting The Cables - HP w15e User Manual

Connecting the Cables

1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Route the cables through the cable guide on the rear of the monitor pedestal.
3. Connect the VGA signal cable to the VGA connector on the rear of the monitor and the other end
to the VGA connector on the computer.
4. Connect one end of the power cable to the AC power connector on the back of the monitor, and
the other end to an electrical wall outlet.
Figure 3-3
WARNING!
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
Disconnect power from the equipment by unplugging the power cord from the electrical outlet.
For your safety, do not place anything on power cords or cables. Arrange them so that no one may
accidentally step on or trip over them. Do not pull on a cord or cable. When unplugging from the
electrical outlet, grasp the cord by the plug.
6 Chapter 3 Setting Up the Monitor
Connecting the Cables
To reduce the risk of electric shock or damage to the equipment: