Table of Contents
Advertisement
Arp Range ............................................................................................[1 oct...4 oct]
This parameter specifies the range for arpeggios in octave steps.
Arp Key Sync ................................................................................................[Off, On]
This parameter specifies whether the arpeggiator will be synchronized with the keyboard, the trigger
pad or the touchpad when notes are sounded.
Off
Sync is off. Notes will not be reset when you play the keyboard, the trigger pad, or the touchpad.
On
Sync is on. When you press the keyboard, the trigger pad or the touchpad, notes will be always reset and
it will start playing from the beginning of the arpeggio pattern.For example, when performing together with
other instruments, you can use this function to align the beginning of the measures.
Arp Swing ...................................................................................... [-100%...+100%]
This parameter specifies the timing where notes will be shifted. You can express rhythms from
straight 8 beats to bouncing shuffles.
Arp Latch ......................................................................................................[Off, On]
This parameter specifies how the arpeggiator will behave when you take your hands off the key-
board, the trigger pad, or the touchpad.
Off
When you take your hands off the keyboard, the trigger pad, or the touchpad, the arpeggiator will stop.
On
Even if you take your hands off the keyboard, the trigger pad, or the touchpad, the arpeggiator will continue
its performance.
Parameters related to the sliders, knobs, F1–F8 buttons and transport buttons
Control Mode ........................................................................... [MIXER , CONTROL]
Specify the control parameter that will be output when you push a slider, a knob or a button.
MIXER: You can use sliders, knobs and buttons to control the mixer as follows.
CONTROL: When you use a slider, a knob or a button, control change messages that were set will
be transmitted.
In your software synthesizer, assign a controller to a desired parameter, by using a control change
message assign function and a Learn function.
TIP For information on how to set up your application, please refer to the instruction manual of your
software.
1
2
3
Arp Swing
–50
Control the pan of each
track.
Control the level of
each track.
4
5
6
7
–24
+24
Move the target tracks.
Control the on/off action
for the mute, solo, and
REC of tracks.
Select a function to
control with the
ASSIGN button.
9
8
9
+50
Hide quick links:
Advertisement
Table of Contents
