Table of Contents
Advertisement
Drill four fixing holes see Fig. G
Position the base into the recess with its front edge as
far forward as the adjoining plinth line will allow.
The reason for placing the base in this position is to al-
low a small strip of beading to be fitted in front of the
appliance feet.
Graphic H
5 x 25 x 605
490
Electrical connection
Information on the electrical connection is given on the
rating plate on the inner edge of the appliance door.
Check that your domestic electrical installation can take
the maximum load required, also taking into account any
other appliances in use.
Caution! Connect the machine to an earthed socket.
Warning! The appliance is supplied with a 13amp
plug fitted. In the event of having to change the fuse
in the plug supplied, a 13amp ASTA approved (BS1363/
A) fuse must be used.
Environment concerns
The symbol
on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
www.zanussi.com
Hardwood strip
5 mm x 25 mm
600-605
Fix the base firmly to the floor using four appropriate
countersunk screws (see Fig. H).
With the appliance installed adjust all four feet ensuring
the machine is stable, and a clearance of approximately
5 mm is left between the top of the machine and the un-
derside of the worktop.
A final check for stability should be carried out with the
machine on spin with a load, this will identify the need
for any further fine adjustment to the feet.
A strip of beading approximately 605 mm W, x 5 mm H,
x 25 mm D must be screwed down into the base directly
in front of the machine's feet, this will provide addition-
al security.
If required an additional door magnet, part number
1242394-00/3 and disc, part number 1242393-00/5 are
available from spare parts.
Caution! The manufacturer does not accept any
responsibility for damage or injury through failure
to comply with the above safety precaution.
Caution! Should the appliance power supply cable
need to be replaced, this MUST be carried out by a
Service Centre.
The power supply cable must be easily accessible
after installing the machine.
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please contact
your local council, your household waste disposal service
or the shop where you purchased the product.
27
Hide quick links:
Advertisement
Table of Contents
