Installation - Zanussi ZWT 71201 WA User Manual

Installation

Unpacking
All transit bolts and packing must be removed before us-
ing the appliance.
You are advised to keep all transit devices so that they can
be refitted if the machine ever has to be transported again.
After removing all the
packaging, carefully lay
machine on it's back to re-
move the polystyrene base
from the bottom.
Unscrew the three bolts
with the supplied spanner.
Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
22
Remove the power supply
cable and the hoses from
the hose holders on the
rear of the appliance.
Slide out the relevant plas-
tic spacers.
rugs etc. Check that the machine does not touch the wall
or other kitchen units.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation.
Caution! Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor. After having levelled the
appliance, tighten the lock nuts.
Raising the appliance
Suspended wooden floors are particularly susceptible to
vibration.
To help prevent vibration we recommend you place a wa-
terproof wood panel, at least 15 mm thick under the appli-
ance, secured to at least 2 floor beams with screws, the
wood panel must extend beyond the front feet.
If possible install the appliance in one of the corners of
the room, where the floor is more stable.
Water inlet
Warning! This appliance must be connected to a
cold water supply
Caution! Before connecting up the appliance to new
pipework or to pipework that has not been used for
some time, run off a reasonable amount of water to flush
out any debris that may have collected
Level the washing ma-
chine by raising or lower-
ing the feet. The feet may
be tight to adjust as they
incorporate a self locking
nut, but the machine
MUST be level and stable.
If necessary, check the
setting with a spirit level.
Any necessary adjustment
can be made with a span-
ner.
www.zanussi.com