Zanussi ZWT 71201 WA User Manual page 20

Problem
Spinning starts late or the machine
does not spin:
The machine does not dry or does
not dry properly:
The laundry is full of different col-
oured fluff:
The machine makes an unusual
noise:
No water is visible in the drum:
20
The electronic unbalance detection device has cut in because the laundry is
not evenly distributed in the drum. The laundry is redistributed by reverse rota-
tion of the drum. This may happen several times before the unbalance disap-
pears and normal spinning can resume. If, after 10 minutes, the laundry is still
not evenly distributed in the drum, the machine will not spin. In this case, re-
distribute the load manually and select the spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the spinning
programme.
The drying time has not been selected.
• Select the drying time.
The water tap is not turned on.
• Open the water tap.
The drain filter is clogged.
• Clean the drain filter.
The machine is overloaded.
• Reduce the laundry load.
The selected drying time or the drying programme was not suitable for the
laundry.
• Select the suitable drying time/programme for the laundry.
The fabrics washed in the previous cycle released fluff of a different colour (re-
fer to "Fluff in the garments" in chapter 'Use - Washing & Drying').
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum repeat the following proce-
dure twice:
• Thoroughly clean the empty drum, the gasket and the door with a wet rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
The machine is fitted with a type of motor which makes an unusual noise com-
pared with other traditional motors. This new motor ensures a softer start and
more even distribution of the laundry in the drum when spinning, as well as
increased stability of the machine.
Machines based on modern technology operate very economically using very
little water without affecting performance.
Possible cause/Solution
www.zanussi.com