Table of Contents
Advertisement
D
Caution! Do not remove the screw 8!
d) Counter-magnet (6)
The appliance is prearranged for a magnetic closure of
the door.
To enable a correct operation of this device, it is neces-
sary to screw the counter-magnet (6) (steel disk + rub-
ber ring) into the inner side of the door. Its position
must correspond to the magnet (4) on the appliance
(see picture D).
4
5
E
Caution! Do not remove the screw 8!
26
4
6
8
6
1
7
3
2
8
If the door has to be opened from left to right, invert the
position of the plates (7), the magnet (4) and the plate
(5) (Fig. B and E). Mount the counter-magnet (6) and
the hinges (1) as previously described.
Recommendations regarding the construction and fit-
ting of a base when the installation requires an integra-
ted appliance to be raised.
Graphic F
5 mm Hardwood strip
40
100
600-605
Front view
Where the appliance has been raised by mounting onto
a wooden base provided by the installer. The material
used to construct the base should have anon slip sur-
face, be water repellent and if possible be one solid
piece.
If it is not possible to use one solid piece, due to the
additional height required, ensure that any additional
strips of timber are glued and screwed to the underside
of the base (see Fig. F).
Graphic G
95
Front edge
50
Top view
Additional pieces
of timber should run
from front to back
600-605
www.zanussi.com
490
Hide quick links:
Advertisement
Table of Contents
