Troubleshooting Connections; Support; Notices - Cardo Systems G9 User Manual

9. TROUBlESHOOTING CONNECTIONS

reseT PairiNG
To delete your paired devices (not including "One+8" pairings):
1. V erify that your G9 is turned ON and in Standby mode (single
BLUE flash every 3 seconds).
2. P ress and hold the
Mobile
will first flash RED. Continue to hold the button until the RED
and BLUE lights begin rapidly alternating.
3. Press and hold the Volume Up Button for 2 seconds.
4. T he PURPLE light will flash 5 times and then the
scala rider G9 will turn OFF, indicating that the Reset was
successfully completed.

10. SUPPORT

For additional information please visit our website at
www.cardosystems.com
FAQ: w ww.cardosystems.com/support/faq
or contact us at: support@cardosystems.com
Phone: U SA and Canada: 1-800-488-0363
International: +49 89 450 36819
iMPOrTaNT
MULTINATIONAL ELECTRONIC COMMERCE COMPANIES AND ONLINE AUCTION WEBSITES ARE NOT
AUTHORIZED TO SELL CARDO PRODUCTS AND PURCHASES FROM SUCH SITES ARE AT YOUR OWN
RISK. TO RECEIVE WARRANTY OR CUSTOMER SERVICE, YOU MUST SUBMIT ORIGINAL RECEIPTS
FROM AUTHORIZED CARDO DEALERS.
PRODUCTS THAT WERE IMPORTED FROM NORTH AMERICA MUST ALSO BE SERVICED IN THE USA.
| |
scala rider scala rider G9 / G9 PowerSet G9 / G9 PowerSet
® ®
24 24
Button for at least 6 seconds. The G9

11. NOTICES

Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user's authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. The
antenna used for this transmitter must not transmit simultaneously with any other antenna or
transmitter, except in accordance with FCC/IC multi-transmitter product procedures.