Brake System Indicator - Honda 2000 RL Owner's Manual

Main Menu
Table of Contents

BRAKE SYSTEM INDICATOR*

*U.S. indicator shown
The Brake System Indicator comes
on when you turn the ignition ON
(II). If the parking brake is not set, it
goes off after you start the engine. If
the parking brake is set, it goes off
when you fully release the parking
brake with the engine running.
If it comes on at any other time, it
indicates a problem with the car's
brake system. In most cases, the
problem is a low fluid level in the
brake fluid reservoir. Press lightly on
the brake pedal to see if it feels
normal. If it does, check the brake
fluid level the next time you stop at a
service station (see page 228). If the
fluid level is low, take the car to your
dealer and have the brake system
inspected for leaks or worn brake
pads.
However, if the brake pedal does not
feel normal, you should take
immediate action. Because of the
brake system's dual-circuit design, a
problem in one part of the system
will still give you braking at two
wheels. You will feel the brake pedal
go down much farther before the car
begins to slow down, and you will
have to press harder on the pedal.
The distance needed to stop will be
much longer.
Brake System Indicator
Slow down by shifting to a lower
gear, and pull to the side of the road
when it is safe. Because of the
longer distance needed to stop, it is
hazardous to drive the car. You
should have it towed, and repaired as
soon as possible. (See Emergency
Towing on page 292.)
If you must drive the car a short
distance in this condition, drive
slowly and cautiously.
If the ABS indicator and the VSA
system indicator come on with this
indicator, have the car inspected by
your dealer immediately.
Taking Care of the Unexpected