Table of Contents
Advertisement
Main Menu
Table of Contents
WEATHER SEAL
BULB
CONNECTOR
HOLD-DOWN WIRE
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
5. Insert the new bulb into the hole,
making sure the bulb is right side
up and the nubs on the bulb base
fit in the indentations in the
headlight assembly. Pivot the hold-
down wire back in place and clip
the end into the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked
7. Push the electrical connector onto
the new bulb.
Turn on the headlights to test the
new bulb.
Replacing a Fog Light Bulb
Your car uses halogen fog light
bulbs. See page
250
for information
on replacing a halogen bulb.
Maintenance
Lights
CONTINUED
Advertisement
Chapters
Table of Contents
