Honda 2000 RL Owner's Manual page 148

Main Menu Table of Contents
3.5 RL with Navigation System
Operating the Radio
The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pushing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
knob.
The band and frequency that the ra-
dio was last tuned to is displayed. To
change bands, press the AM/FM but-
ton. On the FM band, ST will be dis-
played if the station is broadcasting
in stereo. ST will flash if you are driv-
ing in an area where the radio signal
is weak. Stereo reproduction on AM
is not available.
You can use any of three methods to
find radio stations on the selected
band: TUNE, SEEK, or the Preset
buttons.
TUNE — Use the TUNE bar to tune
the radio to a desired frequency.
Push and release the appropriate
side of the bar quickly. The
frequency numbers will change in
small increments.
SEEK — The SEEK function
searches the band for a station with
a strong signal. To activate it, push
either of the SEEK bar ( — or +)
until you hear a beep. Push the bar
on the + side to scan up from the
current frequency, and on the —
side to scan down. It stops when it
finds a station with a strong signal.
Audio System
Preset — You can store the
frequencies of your favorite radio
stations in the six preset buttons.
Each button will store one frequency
on the AM band, and two
frequencies on the FM band.
Comfort and Convenience Features
CONTINUED