Honda 2000 RL Owner's Manual page 255

Main Menu Table of Contents
Lights
CONNECTOR
BOLT
1. Use a wrench to loosen the light
assembly's mounting bolt.
2. Remove the light assembly from
the bumper.
3. Remove the electrical connector
from the bulb by pulling the
connector straight back.
Maintenance
WEATHER SEAL
HOLD-DOWN
WIRE
BULB
4. Remove the rubber weather seal
by pulling on the tab.
5. Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way and remove the
bulb.
6. Insert the new bulb into the hole,
making sure the bulb is right side
up and the nubs on the bulb base
fit in the indentations in the fog
light assembly. Pivot the hold-
down wire back in place and clip
the end into the slot.
7. Install the rubber seal over the
back of the fog light assembly.
Make sure it is right side up; it is
marked
8. Push the electrical connector onto
the new bulb. Turn on the front
fog lights to test the new bulb.
9. Put the light assembly into the
bumper. Tighten the mounting
bolt.