Installing The Ems Si; Step 1. Power Off Hvac Equipment; Step 2. Remove Existing Thermostat; Step 3. Install The Ems Si - Ecobee EMS Si Manual

INSTALLING THE EMS Si

There are 5 steps to install the ecobee EMS Si:

Step 1. Power Off HVAC Equipment

Step 2. Remove Existing Thermostat

Step 3. Install the EMS Si

Step 4. Connect the Wiring
Step 5. Power On HVAC Equipment
Step 1. Power Off HVAC Equipment
Before disconnecting the existing thermostat, or installing the
EMS Si, disconnect the power to the heating and air conditioning
equipment.
Step 2. Remove Existing Thermostat
Disconnect the wires to the existing thermostat and remove
it from the wall (if you are installing the EMS Si in the same
location).
Step 3. Install the EMS Si
The ideal location for the thermostat is approximately 5 ft (1.5 m)
above floor level in the main living area.
Do not install the thermostat:
Close to sources of heat such as incandescent lights
Near supply heating/cooling sources
In direct sunlight
On exterior, non-insulated or poorly insulated walls
In the kitchen or other areas of potentially high heat and/or
humidity
7