I/O Module Port Mapping─Half-Height Blades; Standard Lom (Dual-Port) And Network Daughter Card (Quad-Port) Mapping - Dell PowerEdge M1000E BMX01 Owner's Manual

Blade n and Blade (n + 8)
NOTE: n denotes a
variable value from 1
to 8.
Mezz_FAB_C_Blade n
+8_Port4
NOTE: Even though PowerEdge M610x is a full blade system, only two mezzanine card slots (MEZZ1_Fab_C1 and
MEZZ2_FAB_B1) in the expansion bay are available for use. The other two slots on the system board
(MEZZ1_FAB_C and MEZZ2_FAB_B) are occupied by the mezzanine interface card which provides connectivity
between the PCIe expansion-card riser and the system board.
The following table illustrates the I/O module port mapping for PowerEdge M610x in bay
Table 6. Example of I/O Module Port Assignments - PowerEdge M610x Blade 1
Blade 1
Mezzanine Card C (port 1
and port 2)
Mezzanine Card C (port 3
and port 4)
Mezzanine Card B (port
1 and port 2)
Mezzanine Card B (port
1 and port 2)
I/O Module Port Mapping─Half-Height Blades

Standard LOM (Dual-Port) and Network Daughter Card (Quad-Port) Mapping

Each standard LOM has two port connections. For a half-height blade in bay
Integrated LOM, connection 1 connects to I/O module A1, port
n .
A2, port
Half-height blades with network daughter card (M710HD) hosts two network controllers (LOM1 and LOM2), each with
two port connections. For a half-height blade in bay
• LOM1, connection 1 connects to I/O module A1, port
• LOM2, connection 1 connects to I/O module A1, port
+16 .
NOTE: If the I/O modules A1 and A2 are not quad-port capable, then the LOM2 ports (NIC3 and NIC4) gets disabled
during system boot.
For example, in a half-height blade, in slot 5:
• Integrated LOM1 connection 1 connects to I/O module A1, port 5.
• Integrated LOM1 connection 2 connects to I/O module A2, port 5.
• Integrated LOM2 connection 1 connects to I/O module A1, port 21.
B1 C1
A1 B1
Port 9
Port 25
n :
I/O Module
C2
(n+24)
Port
I/O Module
C1 C2
Port 9 Port 9
Port 25 Port 25
n :
n . Integrated LOM, connection 2 connects to I/O module
n . LOM1, connection 2 connects to I/O module A2, port n .
n+16 . LOM2, connection 2 connects to I/O module A2, port n
B2
n .
B2 A2
Port 9
Port 25
43