Mezzanine Cards; Poweredge M610X Only; Full-Height Blades; Half-Height Blades - Dell PowerEdge M1000E BMX01 Owner's Manual

IOM Slot A1
Dual Port
Dual Port
Quad or Greater Port
Quad or Greater Port
Quad or Greater Port

Mezzanine Cards

PowerEdge M610x Only

PowerEdge M610x supports two mezzanine cards. Mezzanine cards can be installed in both the slots on the midplane
interface card.
NOTE: PowerEdge M610x is a full-height blade but supports only two mezzanine cards in the expansion bay. The
two mezzanine slots on the M610x system board (MEZZ2_FAB_B and MEZZ1_FAB_C) are reserved for the
mezzanine interface card.

Full-Height Blades

Full-height blades support four mezzanine cards:
• Slot Mezz1_Fabric_C and slot Mezz3_Fabric_C support Fabric C. They must match the fabric type of the I/O
modules installed in I/O module slots C1 and C2.
• Slot Mezz2_Fabric_B and slot Mezz4_Fabric_B support Fabric B. They must match the fabric type of the I/O
modules installed in I/O module slots B1 and B2.

Half-Height Blades

Half-height blades support two mezzanine cards:
• Mezzanine card slot C supports Fabric C. This card must match the fabric type of I/O modules installed in I/O
module slots C1 and C2.
• Mezzanine card slot B supports Fabric B. This card must match the fabric type of I/O modules installed in I/O
module slots B1 and B2.
The following table shows various supported combinations of mezzanine cards and I/O modules.
IOM Slot A2
Dual Port
Quad or Greater Port
Empty
Dual Port
Quad or Greater Port
NIC3 and NIC4 (Enabled/
Disabled)
Disabled
Enabled
Enabled
Enabled
Enabled
Port Auto-Disablement
Active
Inactive
Inactive
Inactive
Inactive
35