Show Modem Configuration - Cisco 3600 Series User Manual

For cisco 3600 series digital modems
Hide thumbs Also See for 3600 Series:
Table of Contents

Advertisement

V.110 Support for Cisco 3600 Series Digital Modems

show modem configuration

To display the current modem configuration for digital MICA technologies modems loaded inside an
access server or router, use the show modem configuration EXEC command.
Syntax Description
slot/port
Defaults
There are no default behaviors or values for this command.
Command Modes
EXEC
Command History
Release
11.2P
12.1(5)T
Examples
The following example shows the display output when using the show modem configuration command.
A specific modem, 0/0, has been designated. V.110 information is highlighted in this example.
Router# show modem configuration 0/0
S-Reg
——-|——-|———————————————
show modem configuration [slot/port]
(Optional) Specifies the location of a slot and modem port. If this number
is not specified, statistics for all connected modems are displayed.
Remember to include the forward slash (/) when entering this variable.
Modification
This command was introduced.
This command was modified to show output display for Cisco 3600 series
digital modems that support V.110.
Value
Meaning
S-- = 1
Country Code is Default u-law
S00 = 0
Auto Answer immediately
S01 = 0
Reserved
S02 = 43
escape character is 0x2B or '+'
S03 = 13
carriage return character is 0xD
S04 = 10
line feed character is 0xA
S05 = 8
backspace character is 0x8
S06 = 2
pause 2 seconds before blind dialing
S07 = 60
wait up to 60 seconds for carrier after dialing
S08 = 2
comma adds 2 second dial delay
S09 = 317
BitMap register value = 0x13D
S10 = 14
1.4 second delay for hangup after carrier loss
S11 = 0
In Answer Mode
S12 = 3
3 Data Bits
S13 = 3
Space Parity
S14 = 1
1 Stop Bits
S15 = 1
V.42 ODP generation enabled
S16 = 50
5.0 second Error Correction autodetect timeout
S17 = 100
10.0 second Error Correction negotiation timeout
S18 = 13
Error Correction fallback char is 0xD
S19 = 12
Error Correction retransmission limit is 12
S20 = 256
Error Correction frame length is 256 octets
S21 = 3
V42bis or MNP Data Compression
show modem configuration
Cisco IOS Release 12.1(5)T
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

V.110 support

Table of Contents