Cisco uBR900 Series Configuring page 93

Table 10 Possible but Uncommon Cable Interface Reset Causes (continued)
Message
CMAC_LOG_RESET_SERVICE_NOT_AVAILABLE
CMAC_LOG_RESET_T6_RETRIES_EXHAUSTED
CMAC_LOG_RESET_MAINTENANCE_WATCHDOG_DRIVER
CMAC_LOG_RESET_NET_ACCESS_MISSING
CMAC_LOG_RESET_FAILED_WRITE_ACCESS_CONTROL
CMAC_LOG_RESET_DHCP_FAILED
CMAC_LOG_RESET_CANT_START_DS_TUNER_PRCESS
CMAC_LOG_RESET_TOO_MANY_DS_LOCKS_LOST
CMAC_LOG_RESET_NO_SEND_TO_DS_TUNER_PROCESS
CMAC_LOG_RESET_DS_TUNER_WATCHDOG
CMAC_LOG_RESET_UNABLE_TO_SET_MIB_OBJECT
CMAC_LOG_RESET_MIB_OBJECT_PROCESS_WATCHDOG
Description
The CMTS has failed the Cisco uBR900 series'
registration because a required or requested class of
service is not available.
The CMTS failed too many times to respond to a
REG-REQ message.
The Cisco uBR900 series MAC layer failed to detect a
change in the interface driver.
The Network Access parameter is missing from the
DOCSIS configuration file.
The Cisco uBR900 series was unable to set the Write
Access Control for an SNMP parameter as specified by
the DOCSIS configuration file.
The DHCP server did not respond with all the required
values. The required values are: IP address, network
mask, TFTP server IP address, TOD server IP address,
DOCSIS configuration file name, and time zone offset.
The Cisco uBR900 series was unable to start the internal
process used to manage the downstream tuner.
Downstream QAM/FEC lock has been lost too many
times.
The Cisco uBR900 series MAC-layer process was unable
to communicate with the downstream tuner management
process.
The downstream tuner process failed to report its
continuing operation for a long period of time.
The Cisco uBR900 series was unable to set an SNMP
parameter as specified by the DOCSIS configuration file.
The internal MIB object took too long to process the
entries in the DOCSIS configuration file.
Configuring the Cisco uBR900 Series Cable Access Routers 93
show controllers cable-modem mac