Cisco uBR900 Series Configuring page 34

Supported MIBs and RFCs
•
Cable-specific MIBs—These MIBs provide information about the cable interface and related
information on the Cisco uBR900 series cable access router. They include both
DOCSIS-required MIBs and Cisco-specific enterprise MIBs. If your network management
applications have not already been configured for the Cisco uBR900 series cable access router,
these MIBs must be loaded.
Cable-Specific MIBs
Table 4 shows the cable-specific MIBs that are supported on the Cisco uBR900 series cable access
router. This table also provides a brief description of each MIB's contents and the Cisco IOS
software release in which the MIB was initially functional—earlier releases might have had
unsupported prototype versions of the MIB; later releases might have added new attributes and
functionality. Because of interdependencies, the MIBs must be loaded in the order given in the table.
Note
(ftp://ftp.cisco.com/pub/mibs/ or http://www.cisco.com/public/mibs). Most MIBs are available in
both SNMPv1 and SNMPv2 versions; the SNMPv1 versions have V1SMI as part of their filenames.
Table 4 Supported MIBs for the Cisco uBR900 Series Cable Access Router
MIB Filename
SNMPv2-SMI.my
SNMPv2-SMI-V1SMI.my
SNMPv2-TC.my
SNMPv2-TC-V1SMI.my
CISCO-SMI.my
CISCO-SMI-V1SMI.my
CISCO-TC.my
CISCO-TC-V1SMI.my
IF-MIB.my
IF-MIB-V1SMI.my
CISCO-CABLE-SPECTRUM-MIB.my
CISCO-CABLE-SPECTRUM-MIB-V1SMI.my
DOCS-IF-MIB.my
DOCS-IF-MIB-V1SMI.my
DOCS-BPI-MIB.my
CISCO-DOCS-EXT-MIB.my
CISCO-DOCS-EXT-MIB-V1SMI.my
CABLE-DEVICE-MIB.my
CABLE-DEVICE-MIB-V1SMI.my
34 Cisco IOS Release 12.0(7)T
The names given in Table 4 are the filenames for the MIBs as they exist on Cisco's FTP site
Description
Specifies the Structure of Management Information (SMI) for SNMPv2, as
defined in RFC 1902.
Defines the textual conventions as specified in pages 4, 10-11 of RFC 854.
Specifies the Structure of Management Information (SMI) for Cisco's
enterprise MIBs.
Defines the textual conventions used in Cisco's enterprise MIBs.
Describes generic objects for the Layer 3 network interface sublayers. This
MIB is an updated version of MIB-II's if table, and incorporates the
extensions defined in RFC 1229.
Describes the spectrum management flap list attributes.
Describes the DOCSIS-compliant Radio Frequency (RF) interfaces in cable
modems and cable modem termination systems. (This MIB is being updated
on a release basis to add RFC2670 support as needed.)
Describes the attributes for the DOCSIS-specified Baseline Privacy
Interface (BPI) on cable modems and the CMTS (available in an SNMPv2
version only).
Extends the DOCSIS standard RFI MIB (DOCS-IF-MIB)
with Cisco-specific extensions, such as QoS attributes and connection status
and other information regarding the cable modems and CPE devices
supported by the CMTS.
Contains generic cable-related objects for DOCSIS-compliant cable
modems.
Release
12.0(4)XI
12.0(4)XI
12.0(4)XI
12.0(4)XI
12.0(4)XI
12.0(5)T1
12.0(4)XI
12.0(5)T
partial support:
12.0(4)XI
full support:
12.0(5)T1
12.0(4)XI