Cisco uBR900 Series Configuring page 33

•
•
•
Note
cards, Cisco IOS Release 11.3(7)NA or later must be running on the Cisco uBR900 series cable
access router.
In order to use the Cisco uBR900 series cable access router for VoIP-over-cable applications, the
following additional conditions must be met:
•
Supported MIBs and RFCs
The Cisco uBR900 series cable access router supports the following categories of MIBs:
•
•
•
The CMTS system administrator must ensure appropriate databases are updated to activate and
support the new subscriber account in the provisioning, billing and/or network management
systems in place for your network once each cable access router is registered with the CMTS.
The PC(s) connected to the Cisco uBR900 series cable access router must be configured for IP.
Cisco IOS Release 11.3(4)NA or later must be running on the Cisco uBR900 series cable access
router. When the cable access router is up and running, you can display the Cisco IOS release
number by entering the show version command from user EXEC mode.
If the Cisco uBR7246 universal broadband router at the cable headend is using MC16 modem
In order to run VoIP Fax, the uBR900 series cable access router must be configured for voice and
you must be using Cisco IOS Release 12.0(5)T or higher.
SNMP standard MIBs—These are the MIBs required by any agent supporting SNMPv1 or
SNMPv2 network management. Specific MIBs in this category include:
— CISCO-PRODUCT-MIB
— CISCO-CHASSIS-MIB
— CISCO-SYSLOG-MIB
— CISCO-FLASH-MIB
— BRIDGE-MIB
— IF-MIB
— CiscoWorks/CiscoView
The Cisco Voice MIBs consist of the following components:
— VOICE-IF-MIB
— VOICE-DIAL-CONTROL-MIB
— VOICE-ANALOG-MIB
— DIAL-CONTROL-MIB
— CISCO-DIAL-MIB
— SGCP-MIB
Cisco's platform and network-layer enterprise MIBs—These MIBs are common across most of
Cisco's router platforms. If your network management applications are already configured to
support other Cisco routers, such as the Cisco 2600 series or Cisco 7200 series, no further
configuration is needed unless the version of Cisco IOS software being used has updated these
MIBs.
Configuring the Cisco uBR900 Series Cable Access Routers 33
Supported MIBs and RFCs