Cisco uBR900 Series Configuring page 125

debug cable-modem interrupts
To debug Cisco uBR900 series interrupts, use the debug cable-modem interrupts command in
privileged EXEC mode . To turn the debugging messages off, use the no form of this command.
Syntax Description
This command has no keywords or arguments.
Defaults
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Release
11.3 NA
Examples
The following example shows sample debug output for Cisco uBR900 series interrupts.
[no] debug cable-modem interrupts
uBR924# debug cable-modem interrupts
*** BCM3300_rx_mac_msg_interrupt ***
*** BCM3300_rx_mac_msg_interrupt ***
### BCM3300_tx_interrupt ###
*** BCM3300_rx_mac_msg_interrupt ***
### BCM3300_tx_interrupt ###
*** BCM3300_rx_mac_msg_interrupt ***
### BCM3300_tx_interrupt ###
### BCM3300_tx_interrupt ###
### BCM3300_tx_interrupt ###
### BCM3300_tx_interrupt ###
Modification
This command was introduced.
Configuring the Cisco uBR900 Series Cable Access Routers 125
debug cable-modem interrupts