Cisco uBR900 Series Configuring page 67

interface cable-modem
To specify the cable interface on a Cisco uBR900 series cable access router, enter the interface
cable-modem command from global configuration mode.
Syntax Description
number
Defaults
Disabled
Command Modes
Global configuration
Command History
Release
11.3 NA
Usage Guidelines
When this command is entered, the Cisco uBR900 series cable access router switches from global
configuration mode to interface configuration mode.
Examples
The following example brings up cable access router interface 0 and displays the available
cable-modem interface configuration commands:
interface cable-modem number
The interface number of the cable interface on the rear panel of the cable access
router.
uBR924(config)# interface cable-modem 0
uBR924(config-if)# cable-modem ?
compliant Enter compliant modes for interface
downstream Downstream channel characteristics
fast-search Enable/disable the DS fast search
upstream upstream channel characteristics
voip Options for Voice over IP traffic over the cable interface
uBR924(config-if)#
Modification
This command was introduced.
Configuring the Cisco uBR900 Series Cable Access Routers 67
interface cable-modem